Baracoda Barcode Reader Manuel d'utilisateur télécharger pdf (Page 4)

RoadRunners BRR-L Programming guide May 2006

2 General Configuration

2.1 Reset all parameters:

The reading of the "Default settings” label turns all the parameters of the BRR-L back to default settings and

switches it off.

Reset factory defaults

\VT\VTt\NUL\NUL\FF\FF

set defaults

2.2 Erase all barcodes in memory

The RoadRunners has the ability to store barcodes in its internal memory (both in batch mode and in Real Time

with “No Data Loss Mode” ON). By reading the following barcode you will empty the internal memory of the

scanner.

Empty memory

\VT\VT\FNC4|\NUL\NUL\FF\FF

erase stored barcodes

2.3 Baracoda advanced features

2.3.1 Switch on delay

In order to switch on the BRR-L in its standard mode, you should just press the trigger. You can set up the

scanner to be switched on only after keeping the trigger pressed for two seconds by reading the appropriate

barcode.

Switch on delay : 2 seconds

\VT\VTz\NUL\SOH\ETX\FF\FF

switch on delay : 2 secs

Switch on delay : 0 second (*)

\VT\VTz\NUL\SOH\SOH\FF\FF

switch on delay : 0 sec

1 2 3 4 5 6 7 8 9 ... 28 29

Pas de commentaire

Baracoda Barcode Reader Manuel d'utilisateur Page 4